Jump to content

Aap01 help needed. Firing itself after auto burst.


jake25
 Share

Recommended Posts

Hi all. Amateur aap01 owner here, so auto mode was always fine before i installed a new trigger on it. I used abit of auto then i stopped firing then out of no where it fired itself. Is it trigger issue? 

 

Help Greatly appreciated 

Link to comment
Share on other sites

  • 1 month later...

Hi

still having this problem? 
did you try playing with trigger adjustments? Most probably it’s one of the gears inside, those can wear off just from looking at them too long. One of AAP features. I’d suggest fitting new cow cow set and add auto sear as well for good measure. 

Link to comment
Share on other sites

Check your hammer set, feel free to take a photo and post it here if you're unsure.

Link to comment
Share on other sites

  • 1 month later...

Bit late on the reply. All i ended up doing was buying a new aap unit instead. Suspicions was it was purchased second hand and should imagine it was worn. Running a complete stock one now.

Only changed hop unit and barrel, bit of luck a new unit lasts long enough.

 

Will only be using semi mode ran on HPA

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...