Hi Capa help

By emilianoksa,
December 3, 2022 in Gas Guns

This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and possibly forgotten) topic.

Recommended Posts

emilianoksa

Posted December 3, 2022

- Share

Posted December 3, 2022

Recently changed the trigger blade on my TM 5.1.

Straightforward job normally.

However, with the slide fitted, the hammer refused to release when the trigger was pulled.

Normally the culprit would be the sear leaf spring.

However with the slide removed the trigger and hammer work perfectly.

If I cock the hammer with my finger it falls when I pull the trigger. Even when the slide is put back on but not racked.

But when I rack the slide to cock the hammer, the trigger will no longer release it.

I was hoping not to have to disassemble the hammer unit, but I can only think the problem is to do with the disconnector.

Any suggestions would be appreciated.

Link to comment

Share on other sites

This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and possibly forgotten) topic.