stubarber Posted April 14, 2020 Posted April 14, 2020 Hi, I need some help as my gun has stopped working after I dropped it. I have taken it apart per the manual and checked that there are no broken bits and can't find any issues. The slide pulls back as before but is a bit notchy. Is there someone that can help or is it destined for the shop to be repaired.
glockkidd Posted April 14, 2020 Posted April 14, 2020 Hi pal, sorry that you’re having issues, can you send a few high res pictures of the inside of the pistol from different angles. Also send a couple with the slide attached, just want to see how it sits. Cheers Dan I’m thinking that the nozzle spring may be damaged/stuck thus catching when the slide is pulled to the rear
Guest Posted April 14, 2020 Posted April 14, 2020 Your knocker lock looks damaged, it should be raised, certainly when the hammer is locked down You don’t show the bbu in the slide, it’s more likely that is damaged, particularly as it’s a G18
stubarber Posted April 14, 2020 Author Posted April 14, 2020 7 minutes ago, rocketdogbert said: You’re knocker lock looks damaged, it should be raised, certainly when the hammer is locked down You don’t show the bbu in the slide, it’s more likely that is damaged, particularly as it’s a G18 Sorry rocketdogbert, I am new to this. Is the knocker lock the small catch on the left side of the hammer assembly? Is this the photo you mean?
Guest Posted April 14, 2020 Posted April 14, 2020 18 minutes ago, stubarber said: Is the knocker lock the small catch on the left side of the hammer assembly? Yup, does it spring up when you lock the hammer down? BBU is at the rear of the slide, does it look like there’s excessive wear?
stubarber Posted April 14, 2020 Author Posted April 14, 2020 No the lock metal bit only goes up and down if I turn it upside down. The bbu seems ok to me. I just taken it out and it missing the spring underneath it, would this stop it from firing?
Guest Posted April 14, 2020 Posted April 14, 2020 38 minutes ago, stubarber said: No the lock metal bit only goes up and down if I turn it upside down. The bbu seems ok to me. I just taken it out and it missing the spring underneath it, would this stop it from firing? It MIGHT. Put the spring back. Normally it run-away fires without the knocker lock, so you may have just lost the spring whilst re-assembling
stubarber Posted April 15, 2020 Author Posted April 15, 2020 thanks rocketdogbert it seems to have fixed it but now the hammer stays fully open and discharges the gun in one pull. i will take it apart again and check incase there is a jam.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.