ryanlim2000 Posted July 12, 2018 Share Posted July 12, 2018 Hey, Not sure where this goes, but I'm planning to get an ICS L85 or a spring L85 to tear it apart and put a 3D printed SAR-21 exterior on it. I've been advised previously to get an AUG, but due to the cost of AUGs against the L85, I'll probably go with it. Been looking at 3D printing for the parts and its come up to around USD70-100 for them to design out the parts as per military specifications, but I've not checked for the cost of 3D printing yet. The 3D printing person was going to do it with all the rifle parts as well, but I'm not sure if thats a good idea, or how much of the rifle parts to keep. The main issue I'm facing is that the firing chamber is part of the system that holds the rifle in place and how would I fit an AEG or spring rifle's parts inside this "shell" Cheers Link to comment Share on other sites More sharing options...
Duff Posted July 12, 2018 Share Posted July 12, 2018 Damn. Those photos are clean. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.