Will these be ok ?

[RubenR]

I'm am planning on putting these in my kwa m4 cqb and just wondered if they would fit ?

 

http://www.fire-support.co.uk/product/madb...re-barrel-285mm

 

http://www.zerooneairsoft.com/product_info...roducts_id=6288

 

http://www.fire-support.co.uk/product/guar...m90-sp90-spring

 

http://www.fire-support.co.uk/product/guar...-ver2-gearboxes

 

If not what could I use instead ?

 

Cheers

[RubenR]

Anyone ?

[MilsimJunkie3]

Anyone ?

 

Hi, they should all fit apart from that spring guide, 2GX KWA's use a version 3 spring guide but there pretty good as it, i wouldnt change it unless its broken,

 

Hope this helps

[Ian_Gere]

You don't actually need a high torque motor to pull an M90 spring.

 

Just in case you're unsure, high torque means more force applied to turning the motor shaft than a standard motor. You'd only need that if the spring you were putting in was more powerful than the one the original motor was designed for. If you want a higher rate of fire and/or a faster response from when you pull the trigger until the BB is fired, you could upgrade to a high speed motor, but alternatively, since you're downgrading your spring (right? Surely it came with at least a M100 inside?), you could just up the voltage of your battery 1 cell - say from 8.4V to 9.6V.

 

With your tight bore barrel I'd get a really good air nozzle, because you are going to have more compression inside the barrel now, so making sure of a good seal makes sense.

 

It depends what you're trying to achieve really...?