We Glock Eu18

[stubarber]

Hi, I need some help as my gun has stopped working after I dropped it.

I have taken it apart per the manual and checked that there are no broken bits and can't find any issues.

The slide pulls back as before but is a bit notchy.

Is there someone that can help or is it destined for the shop to be repaired.

 

[glockkidd]

Hi pal, sorry that you’re having issues, can you send a few high res pictures of the inside of the pistol from different angles. Also send a couple with the slide attached, just want to see how it sits. 

Cheers 

Dan 

I’m thinking that the nozzle spring may be damaged/stuck thus catching when the slide is pulled to the rear 

 

[stubarber]

Thanks Dan.

View attachment 56110

View attachment 56111

View attachment 56112

View attachment 56113

 

[Guest]

Your knocker lock looks damaged, it should be raised, certainly when the hammer is locked down

You don’t show the bbu in the slide, it’s more likely that is damaged, particularly as it’s a G18

 

[stubarber]

You’re knocker lock looks damaged, it should be raised, certainly when the hammer is locked down

You don’t show the bbu in the slide, it’s more likely that is damaged, particularly as it’s a G18

Click to shrink...

Sorry rocketdogbert, I am new to this.

Is the knocker lock the small catch on the left side of the hammer assembly?

Is this the photo you mean?

View attachment 56114

View attachment 56115

 

[Guest]

Is the knocker lock the small catch on the left side of the hammer assembly?

Click to shrink...

Yup, does it spring up when you lock the hammer down?

BBU is at the rear of the slide, does it look like there’s excessive wear?

 

[stubarber]

No the lock metal bit only goes up and down if I turn it upside down.

The bbu seems ok to me.

I just taken it out and it missing the spring underneath it, would this stop it from firing?

 

[Guest]

No the lock metal bit only goes up and down if I turn it upside down.

The bbu seems ok to me.

I just taken it out and it missing the spring underneath it, would this stop it from firing?

Click to shrink...

It MIGHT. Put the spring back. Normally it run-away fires without the knocker lock, so you may have just lost the spring whilst re-assembling

View attachment 56116

 

[stubarber]

thanks rocketdogbert

it seems to have fixed it but now the hammer stays fully open and discharges the gun in one pull.

i will take it apart again and check incase there is a jam.