• Hi Guest. Welcome to the new forums. All of your posts and personal messages have been migrated. Attachments (i.e. images) and The (Old) Classifieds have been wiped.

    The old forums will be available for a couple of weeks should you wish to grab old images or classifieds listings content. Go Here

    If you have any issues please post about them in the Forum Feedback thread: Go Here

G&G firehawk stopping firing/cutting out

Joined
Apr 27, 2018
Messages
367
Reaction score
75
Was in the middle of a skirmish before and the gun would sometimes stop firing and the trigger would be stuck, would have to switch it from auto back to semi, noticed it was firing multiple round on some occasions and it would cut out on semi on and off, sometimes firing slower and sometimes faster.

Using 7.4v 1300 cranestock lipo 25-50c, charged it the other day but not before game? 

 
stop firing and the trigger would be stuck
Describe that in more detail. Is it like the gun is in safe and the trigger wont move. Or has the trigger got stuck in the fully pulled position? Or is the trigger moving like normal and the gun just isn't shooting.

 

it was firing multiple round on some occasions
Is that in semi, so a single shot is double shooting, Or is the gun letting multiple BB's out at a time.

 

it would cut out on semi on and off
Cut out, or the trigger would jam?

 

I would start by having a look at the motor contacts and fuse. Shoot the gun with the fuse exposed and see if it's glowing. If it is the fuse needs uprating and you are suffering from a bit of increased resistance when the fuse is hot.

Have you changed the motor? or removed the motor recently?

Have you done any recent soldering?

How old is the gun?

When was it last serviced, and has it been skirmished without fault since?

 
Describe that in more detail. Is it like the gun is in safe and the trigger wont move. Or has the trigger got stuck in the fully pulled position? Or is the trigger moving like normal and the gun just isn't shooting.

 

Is that in semi, so a single shot is double shooting, Or is the gun letting multiple BB's out at a time.

 

Cut out, or the trigger would jam?

 

I would start by having a look at the motor contacts and fuse. Shoot the gun with the fuse exposed and see if it's glowing. If it is the fuse needs uprating and you are suffering from a bit of increased resistance when the fuse is hot.

Have you changed the motor? or removed the motor recently?

Have you done any recent soldering?

How old is the gun?

When was it last serviced, and has it been skirmished without fault since?
The gun would completely jam as if its in safe, then I would switch to auto then back to semi to fix it.

Was firing multiple sometimes in semi

Trigger would cut out in semi, sometimes it would fire faster and sometimes it would be slower, I was timing the trigger pulls as best as I could.

Its brand new, bought it from patrolbase around 1-2 weeks ago and first time I have skirmished it. 

 
Its brand new, bought it from patrolbase around 1-2 weeks ago and first time I have skirmished it.
 Call patrol base.

Take a video of the problems, and have them replace the gun at their cost since the issues have shown on the first shoot.

I have an idea what the problems could be but with the warranty still intact you don't want to go poking about in the gearbox.

 
 Call patrol base.

Take a video of the problems, and have them replace the gun at their cost since the issues have shown on the first shoot.

I have an idea what the problems could be but with the warranty still intact you don't want to go poking about in the gearbox.
Alright will do thanks, ill try and get a vid soon.

Could it be anything to do with battery fully charged it a few days ago so don't know if the charge was low or not. 

 
 Call patrol base.

Take a video of the problems, and have them replace the gun at their cost since the issues have shown on the first shoot.

I have an idea what the problems could be but with the warranty still intact you don't want to go poking about in the gearbox.
Called them, seemed to say it will happen if you pull the trigger too quickly, not sure whether I was or not.

Here's a video



View attachment 36626

 
Last edited by a moderator:
It's a common occurrence when you spam the semi auto on a lot of gear boxes

Essentially, you're not letting the gun finish firing one shot before you're asking it to fire off another. It gets itself into a tizzy and jams up.

Usually a blast of full auto sorts it 

 
Could it be anything to do with battery fully charged it a few days ago so don't know if the charge was low or not.
Not if you read up on lipo saftey.

A lipo when it discharges does it in a very predictable way.

It starts off with a steep voltage drop from 8.4v to about 7.5v, but then levels out for most of the capacity of the battery 7.5v-7v. Then falls off again very quickly when it's almost done and give an shot by shot slowdown (you should pull the battery and swap it out as soon as this starts to happen).

You shouldn't see much variation in gearbox cycle times once it gets past that initial drop off. It should be a stable fire rate. Once it hits the final part of the discharge again you will notice it as significant slowing of the gearbox, but it won't stop shooting it'll just cycle slower.

1300mah is pretty low capacity, so if you were shooting it a lot after the first charge before the skirmish you might have gone out with a battery at only half charge. And if you have taken the battery to the bottom of the capacity into the range where it can no longer cycle the gun and was going very slowly then you might of done significant damage to the lipo. You have to watch them and swap them at the start of the final drop off.

If that is the case you need to measure the voltage of the lipo. If it is showing less than 5.8v it might be  unsafe to charge . And it needs charging on a proper charging station that can refuse to charge a depleted/unsafe lipo. Rather than a cheap charger. Your skirmish site will have one of these if you don't.
 

The gun would completely jam as if its in safe, then I would switch to auto then back to semi to fix it.


This sounds like the saftey lever is jamming in the safe position, it probably getting caught on a wire and not falling off properly. It'll need the gearbox opening to check. You have a warranty use it. The video looks to back that up.

The battery in the video looks to be fine BTW, But it's worth leaving that statement up  there^^ to remind you how dangerous lipos can be. If you only have the 1x 1300mAh battery get another so you can swap it out when it starts to fall off.


Send that video to Patrol base. It's good evidence and shows the fault as a fault. They will have to act on it. But you also need to do another video without spamming semi. To prove it's not you spamming causing the issue.

 
Last edited by a moderator:
Not if you read up on lipo saftey.

A lipo when it discharges does it in a very predictable way.

It starts off with a steep voltage drop from 8.4v to about 7.5v, but then levels out for most of the capacity of the battery 7.5v-7v. Then falls off again very quickly when it's almost done and give an shot by shot slowdown (you should pull the battery and swap it out as soon as this starts to happen).

You shouldn't see much variation in gearbox cycle times once it gets past that initial drop off. It should be a stable fire rate. Once it hits the final part of the discharge again you will notice it as significant slowing of the gearbox, but it won't stop shooting it'll just cycle slower.

1300mah is pretty low capacity, so if you were shooting it a lot after the first charge before the skirmish you might have gone out with a battery at only half charge. And if you have taken the battery to the bottom of the capacity into the range where it can no longer cycle the gun and was going very slowly then you might of done significant damage to the lipo. You have to watch them and swap them at the start of the final drop off.

If that is the case you need to measure the voltage of the lipo. If it is showing less than 5.8v it might be  unsafe to charge . And it needs charging on a proper charging station that can refuse to charge a depleted/unsafe lipo. Rather than a cheap charger. Your skirmish site will have one of these if you don't.
 

This sounds like the saftey lever is jamming in the safe position, it probably getting caught on a wire and not falling off properly. It'll need the gearbox opening to check. You have a warranty use it. The video looks to back that up.

The battery in the video looks to be fine BTW, But it's worth leaving that statement up  there^^ to remind you how dangerous lipos can be. If you only have the 1x 1300mAh battery get another so you can swap it out when it starts to fall off.


Send that video to Patrol base. It's good evidence and shows the fault as a fault. They will have to act on it. But you also need to do another video without spamming semi. To prove it's not you spamming causing the issue.
Yeh I have another one, was only a small night game for 2 hours, didn't realise they don't last long.

Ill charge that battery now, do you have to keep topping them up to keep them safe?

So its definitely a fault and not me spamming?

Cheers

 
Ill charge that battery now, do you have to keep topping them up to keep them safe?
For storage you want them on about 3.8v per cell. So 7.4-7.8v. It wants to be on the flat part of the discharge curve, not fully charged, not depleted.

 

So its definitely a fault and not me spamming?
Won't know until I see a video with a controlled semi shoot. If you can make it happen under controlled fire you have a problem, if you can't then it's you shooting style. Normally when it's a trigger lockup due to spamming the trigger runs free and fails to engage, Yours isn't it's been locked back by the safety latch at the front of the gearbox. So I suspect you can still make it happen with a controlled rate of fire.

 
For storage you want them on about 3.8v per cell. So 7.4-7.8v. It wants to be on the flat part of the discharge curve, not fully charged, not depleted.

 

Won't know until I see a video with a controlled semi shoot. If you can make it happen under controlled fire you have a problem, if you can't then it's you shooting style. Normally when it's a trigger lockup due to spamming the trigger runs free and fails to engage, Yours isn't it's been locked back by the safety latch at the front of the gearbox. So I suspect you can still make it happen with a controlled rate of fire.
Made another video, charged the battery up a bit prior to making this.

Seems alright then when I fire quicker seems to jam up and the handle gets warm, must be me then?



 
Yeah looks to be you.

Just keep an eye on it.
Yeah seemed like it from that, seemed different in game also was using a 2inch barrel extension and a tracer also in the skirmish, had the original flash hider on in the video.

Seemed to slow down when I wasn't even firing fast on site but might not be timing the trigger pulls properly in the heat of the moment with my gloves on, will test it sunday if I go.

Ordered a fireproof lipo bag aswell as they seem safer for storage atleast, will get one of those voltage testers aswell.

Cheers 

 
Last edited by a moderator:
Those fireproof bags are for charging as well. Good idea.

Voltage tester  - your better off with a cheap multimeter. You can pick them up for about £10. And for that you get a whole load of useful functions. For the money it's better than anything designed specifically for airsoft.

Voltage testing with them is as easy as selecting the correct function and touching the probes to the battery terminals.

They also come in really handy for looking for electrical faults if you know how to use one. You can use them in the home and car as well. I have a couple because it's the first tool I grab  when I have any electrical problem.

https://www.screwfix.com/p/lap-mas830b-digital-multimeter-600v/75337

 

 
Last edited by a moderator:
Those fireproof bags are for charging as well. Good idea.

Voltage tester  - your better off with a cheap multimeter. You can pick them up for about £10. And for that you get a whole load of useful functions. For the money it's better than anything designed specifically for airsoft.

Voltage testing with them is as easy as selecting the correct function and touching the probes to the battery terminals.

They also come in really handy for looking for electrical faults if you know how to use one. You can use them in the home and car as well. I have a couple because it's the first tool I grab  when I have any electrical problem.

https://www.screwfix.com/p/lap-mas830b-digital-multimeter-600v/75337

 
Ah okay cheers, will probably pick one of them up for sure in a bit then as its only down the road, reasonably priced actually.

Thanks again.

 
18 hours ago, Compulsive Reload said:

Made another video, charged the battery up a bit prior to making this.

Seems alright then when I fire quicker seems to jam up and the handle gets warm, must be me then?



That has to be the noisiest fucking AEG I have ever heard!

 
Is it me or is it misfeeding a lot? 

 
I like the sound personally, on video just sounds like a loud gun, different in person.

Is it me or is it misfeeding a lot? 
Didn't think it was on video, was kind of firing at the hole in the box/video quality is poor.

Was using a lonex hi cap flash mag in it.

 
Last edited by a moderator:
May just be video quality but when looking at the muzzle it seemed it was misfeeding quite a bit. 

 
Back
Top