Jay9876

I did think that so I gave it a clean the other day and same issue is occurring. I’ll give it another go but don’t believe this to the issue There where was a point where the aster was pulling an error code unable to detect the sector gear so maybe sensors are damaged?

I have recalibrated the selector and it seems to read fine on the GCS and I have precooking set to disabled can’t figure out the issue

I am experiencing full auto in semi and semi in full auto this only happens for the first 3-5 shots then it works as it should. I am also experiencing a fps drop by about 70. As well as occasional double fee happens every 50-100 shots. My air compression in the gearbox is fine my air nozzel to hop up chamber is also fine.gears are all shimmed nicely sounds all good and good connections between them as well as a corrected aoe. internals: zci 13:1 gears ssg full shs air compression set apart from the piston head which is asg. Cylinder port is about 2/3 away from the cylinder head. asg ultimate 30k motor m115 spring gate aster running a 11.1 lipo with 25c Prometheus barrel (6.03x128) with a maxx cnc me pro hop up. timed tapet plate. fps sitting around 250 rps is around 30 anyone got any ideas

The maxx hop up came with a spring an o rings for the seal from the hop up to gearbox so I believe that to be the issue Don’t believe that to be the issue

I’ve now thrown a gate aster on the build and at first it was shooting 2 bbs at once but ut seems that issue has now been sorted. But another issue has accrued the fps has dropped down to 200 fps I’ve took the gearbox and rebuilt it a couple of times checking aoe and air seal and both are perfect. Shimming is on point and I can’t figure why the loss Fps. Any suggestions? I’ve now thrown a gate aster on the build and at first it was shooting 2 bbs at once but ut seems that issue has now been sorted. But another issue has accrued the fps has dropped down to 200 fps I’ve took the gearbox and rebuilt it a couple of times checking aoe and air seal and both are perfect. Shimming is on point and I can’t figure why the loss Fps. Any suggestions? What I have in head is the pinion and bevel gear are not properly aligned so the gun isn’t going through a full cycle or would it still complete a cycle

Is there anything else you would recommend I changed for my build

Like I said I’m new to the sport I only started about 3 weeks ago if high rps is seen to be “wanker” territory maybe I won’t go for a higher rps. That was the aim as I just want a really quick trigger response and a high fps to help with range.

I am currently running a g and g fire hawk I want to increase my rps to around 30 whilst having around 330-350 fps. Currently I am running a Prometheus barrel (128mm) (6.03mm) maxx cnc me pro as hop up unit ZCI 13:1 single sector gears shs piston asg piston head shs cylinder head shs nozzle asg ultimate 30k motor asg ultimate m115 spring I currently am running at around 20 rps and 300 fps I am planning to get a mosfet put in this week so I can run a 11.1v lipo. I understand I’m losing a lot of fps due to the barrel length but I’m not looking to replace whole front end. I am new to the sport and this is my first build so any suggestions would be much appreciated.