Luke-airsoft19

😂🤣

It's the shadow from the lighting the top is just a fraction off maybe 1mm or 2mm,but I did forget to grease it.

Is there any particular grease you'd use or just standard run of the mill? It's pretty tight as is so maybe just leaving it as is would be best, you can only notice up close anyway! Thanks for the advice... Really appreciate it 😁

It's solid and doesn't wobble, just really annoying that its so close. It's a nuprol bocca series II I believe, the standard one was just abit short so I wanted something abit longer! It's solid and doesn't wobble, just really annoying that its so close. It's a nuprol bocca series II I believe, the standard one was just abit short so I wanted something abit longer!

Recently brought a new rail system, to replace my old one. Never tried fitting one before and wasn't sure how to do it, there's a slight gap between the top rail on the handguard and the upper receiver, about 1mm maybe 2mm yet I don't feel I can get the barrel nut tighter without damaging something, just wondered if this was normal, or would I be fine trying to get the barrel nut on further?!

Recently brought a new rail system, to replace my old one. Never tried fitting one before and wasn't sure how to do it, there's a slight gap between the top rail on the handguard and the upper receiver, about 1mm maybe 2mm yet I don't feel I can get the barrel nut tighter without damaging something, just wondered if this was normal, or would I be fine trying to get the barrel nut on further?!