Cybergun Thompson

[Cooperman26]

My god! Stress levels 100000x

 

fitted the wood kit, a few amendments needed not an issue. Plug her in, ran a few mags no issues.

 

Then just went dead. 
 

Took her apart, checked the fuse, checked the connections, no issues, took the motor out where it sits plugged in, Pew pew!

 

Awesome! Screwed motor back into place, attached battery, NOTHING. Took the motor back out, tested again, ABSOLUTELY FINE. Put it back in position, DEAD. Did this numerous times. 
 

Am I missing something blindingly obvious!?

Edited 1 hour ago by Cooperman26

[Austeyr]

From what I remember (Cyma/Cybergun same pew?) I had to shim my Cyma Thompson screw as it was able to be tightened too much to the point it wouldn’t fire but if it was loose the grip was also loose.

The same happened on the dodgy KA one I bought off of here a while back, to the point there was at least half a centimetre gap from receiver to pistol grip to get it to work.

 

Not a guarantee it’s the same issue, obviously, but that was my issue so maybe the same for you?