i have put my tac 41 part below so you can see what i am running currently.
when i have bin testing i have found tht i don't get a flat flight path then a rase at he end like i did with my srs.
the hop is not the problem as it will go from a flat (ish) path and dropping off with no hint of a lift at all to lobbing ( lifts the straight out the barrel ) them.
i have found this with a full stalker set up (piston, hop unit, both 60 and 70 hop rubber and barrel (430mm)) and also the one i have put below.
my air seal is good and everything is clean.
power wise it is bang on as well and consistent with about a 4FPS variation.(316FPS)
im using BLS 0.48g bbs.
any thoughts on why its over lifting let me know.
thanks in advance
tac 41a (300 outer barrel with short sup)
stalker spring guide
2.8j rapax spring
stalker piston
larger air brake (all the way in )
stock cylinder head
stock hop unit
hadron nub
medusae slim TDC
silverback 80 hop rubber (AEG typ new)
edgi 330 steel barrel (bridged)
when i have bin testing i have found tht i don't get a flat flight path then a rase at he end like i did with my srs.
the hop is not the problem as it will go from a flat (ish) path and dropping off with no hint of a lift at all to lobbing ( lifts the straight out the barrel ) them.
i have found this with a full stalker set up (piston, hop unit, both 60 and 70 hop rubber and barrel (430mm)) and also the one i have put below.
my air seal is good and everything is clean.
power wise it is bang on as well and consistent with about a 4FPS variation.(316FPS)
im using BLS 0.48g bbs.
any thoughts on why its over lifting let me know.
thanks in advance
tac 41a (300 outer barrel with short sup)
stalker spring guide
2.8j rapax spring
stalker piston
larger air brake (all the way in )
stock cylinder head
stock hop unit
hadron nub
medusae slim TDC
silverback 80 hop rubber (AEG typ new)
edgi 330 steel barrel (bridged)
