solder technique, Will it hold???

[Colin Allen]

Hello @Colin Allen @EDcase.

So today I completely disassembled my ARP 9.

So looking at the internals everything looks ok.

So here are my plans after listening to your advice and tell me if this sounds like a good plan.

Plan A

So first of all I am going to buy the Perum ETU.

https://www.bullseyecountrysport.co.uk/perun-airsoft-gg-etu-mosfet-deans-programable-42705-p.asp?srsltid=AfmBOopl-3dLMmFXsHnnLCgyC5VHWi17ISwZs023THZiOBfJWCoAQUW_

This hopefully will give me an upgrade then rule out if my soldering is the problem.

If it still does not work then plan B I will buy another trigger unit just in case it is worn out and causing all these problems.

https://www.jollysoftair.com/en/control-units/10729-gg-etu-trigger-switch-for-v2-gearbox-gg-sw2.html

Hopefully this will sort it out.

Please let me know you opinion.

Thanks 

The Perun ETU++ is a definite upgrade; however, before replacing stuff it might be wise to check the continuity of the cabling and, in particular, your soldering if you have a multimeter or can get access to one.

 

[Rogerborg]

If you're going to be doing any electrical work, a multimeter is a must.  It takes all the guesswork out of it.

 

[EDcase]

I don't know if more soldering is going to eliminate any soldering problems but its good practice I guess.