Shs High Torque: Lemon?

[Mawky]

The results are in and I'm very happy with them. With the current setup with the 12:1 gears (shortstroked 3 teeth), M120 prommy spring, Tienly 25K motor and the 11.1V 2000mAh 30-50c Lipo the Amp draw is just under 13A on full auto. Haven't really tested semi since the cycle is too short for the RC tester and the numbers on the Leviathan have proven unreliable anyway. 



Tinkering with it so much to test and retest shimming, motors etc. has also given me the opportunity to solve the feeding issue I was having on full auto with the Maxx Model ME Pro in conjuction with Maxx Model nozzle, a tru-hop bucking and ZCI innner barrel (270mm). A shorter 21mm nozzle, sanding the front of the tappet plate to bring the air seal back up and a round ICS gear delayer (one of the round ones that retracts the nozzle a bit further) proved to be the solution. @Sitting Duck, thanks for the tip regarding the round delayer (in another thread from someone else). All of this combined resulted in the following FPS figures. 

Not too bad me thinks and with this I guess my build is finally done apart from adjusting the hop and the red dot. Hopefully all of my testing proves usefull for people looking to get a Tienly or Leviathan. 

Thanks for all the help guys   

 

[Sitting Duck]

The results are in and I'm very happy with them. With the current setup with the 12:1 gears (shortstroked 3 teeth), M120 prommy spring, Tienly 25K motor and the 11.1V 2000mAh 30-50c Lipo the Amp draw is just under 13A on full auto. Haven't really tested semi since the cycle is too short for the RC tester and the numbers on the Leviathan have proven unreliable anyway. 



Tinkering with it so much to test and retest shimming, motors etc. has also given me the opportunity to solve the feeding issue I was having on full auto with the Maxx Model ME Pro in conjuction with Maxx Model nozzle, a tru-hop bucking and ZCI innner barrel (270mm). A shorter 21mm nozzle, sanding the front of the tappet plate to bring the air seal back up and a round ICS gear delayer (one of the round ones that retracts the nozzle a bit further) proved to be the solution. @Sitting Duck, thanks for the tip regarding the round delayer (in another thread from someone else). All of this combined resulted in the following FPS figures. 



Not too bad me thinks and with this I guess my build is finally done apart from adjusting the hop and the red dot. Hopefully all of my testing proves usefull for people looking to get a Tienly or Leviathan. 

Thanks for all the help guys   

Congrats & all that - seriously

PITA v2's with wibbly motor angle & crap in a wanky pistol grip & crap bevels etc...

(sometimes stuff like V2's/M4's can be a friggin' nightmare)

plus nozzle/tappet "window" to chamber bb's etc.... on V2's

a LOT of piss balling about but I concur you now got that setup up pretty close to perfection

(shimming/motor angle/amp draw etc.....)

Which when done correctly makes a heck of a difference to nigh on everything

well done most of all for your perseverance, it paid off in the end

very niiiiiiiiiiice indeed