• 2FA temporarily disabled, emails not working

    Two factor authentication (for most of you 'email a code') has been temporarily disabled while we figure out why emails are not being received by large numbers of users. Emails are not sending site-wide. Please continue to use AF-UK as normal but note that you may be asked to log back in once this is re-enabled.

Rail Wobble- a fix

gimpy-762

Members
Joined
Aug 27, 2010
Messages
1
Reaction score
0
Hi All,

New here :-), Probably been covered a hundred times, rail wobble, I have fixed mine (classic army M15A4) and it rock solid but I reckon it would work on any with similar parts, electric,gas etc

Relatively simple.

at the back of the top rail - the 3 sided bit, I have drilled two holes thorugh the railbody 1 either side that go through the inside groove where it sits on the delta assembly, I then tapped the holes with a 4mm thread, put it back together, added a little thread lock, and used 2 4x4mm grub screws to screw though so that they then sit between the teeth of the of the ring, thats it job done.

MAKE SURE that you measure the holes so that when drilled they sit between the teeth not directly over the points of the teeth. if like on my classice army you have two lumps inside the groove on the inside they should be perfect, BUT CHECK first, you may get away with 4x8mm grub screws if you cant find 4x4, radio control model shops sell them £3 for 10 aprox.

Hope this is of some use

Cheers

 
Back
Top