• 2FA temporarily disabled, emails not working

    Two factor authentication (for most of you 'email a code') has been temporarily disabled while we figure out why emails are not being received by large numbers of users. Emails are not sending site-wide. Please continue to use AF-UK as normal but note that you may be asked to log back in once this is re-enabled.

Gun picture thread

very nice!....

I do like the weather / used look!

wont do it to my CXPUK1 yet but it will need to happen, probably after warranty runs out!

 
Not skirmished it yet as was too windy yesterday to set up the hop correctly. It is currently pumping out 400 ish fps and the few shots I have taken with it seem very promising.

Cost £91 in customs and VAT and Parcel Farce charges to get it here.

It takes AEG barrels, bucking and springs. Ummmm good luck tapping the mags, it is a springer not GBBR lol

 
Not skirmished it yet as was too windy yesterday to set up the hop correctly. It is currently pumping out 400 ish fps and the few shots I have taken with it seem very promising.

Cost £91 in customs and VAT and Parcel Farce charges to get it here.

It takes AEG barrels, bucking and springs. Ummmm good luck tapping the mags, it is a springer not GBBR lol
For some reason I had it in my head it was gas lol

Only thing I can see being a pain with it is the way it feeds and the other internals :(

 
The cocking of the bolt is harder to get used to than a vsr and requires practice. Will be even tougher with the new spring in it when it arrives. The trigger mechanism is far simpler than a vsr though and is steel so should be pretty strong. What do you find weird about how it feeds? BB fed from mag direct into hop as it is on all airsoft guns?

 
Last edited:
Y46R4vm.jpg


 
^^For one hideous minute there I read that as "Nice crimbo paint job" :blink: :wacko: :unsure:

 
Back
Top