-
Hi Guest. Welcome to the new forums. All of your posts and personal messages have been migrated. Attachments (i.e. images) and The (Old) Classifieds have been wiped.
The old forums will be available for a couple of weeks should you wish to grab old images or classifieds listings content. Go Here
If you have any issues please post about them in the Forum Feedback thread: Go Here
GBBR Drop in ELF Trigger
- Thread starter nappa
- Start date
Lyndication
Members
- Nov 26, 2024
- 500
- 671
Short answer is no.
MWS and WE replicas use a trigger box setup that won't fit a real spec trigger like that.
VFC, GHK, and Viper Tech are closer, but the hammers are substantially different on those as they're designed to rest at about 30-45 degrees rather than straight vertical, to mitigate wear and the force needed to reset the hammer. On all three the hammers are also wider than real spec, to spread the force on the bolt carrier as it resets them.
You could cludge it in there a bit by welding an extension onto the firing pins but it'd still run far worse than stock, especially as the hammer spring will be very stiff compared to Airsoft ones.
I gotta ask: why?
MWS and WE replicas use a trigger box setup that won't fit a real spec trigger like that.
VFC, GHK, and Viper Tech are closer, but the hammers are substantially different on those as they're designed to rest at about 30-45 degrees rather than straight vertical, to mitigate wear and the force needed to reset the hammer. On all three the hammers are also wider than real spec, to spread the force on the bolt carrier as it resets them.
You could cludge it in there a bit by welding an extension onto the firing pins but it'd still run far worse than stock, especially as the hammer spring will be very stiff compared to Airsoft ones.
I gotta ask: why?
Similar threads
