So ive got a TM Scar-CQC, i bought an Acetech at1000 and fitted it today. now the TM Scar has a 14ccw thread as does the acetech but then i try to screw it on its very loose, once it gets to the end of the scar's threat it gets tight, however it still feels a little bit wobbly. does anyone else have this issue?
-
Hi Guest. Welcome to the new forums. All of your posts and personal messages have been migrated. Attachments (i.e. images) and The (Old) Classifieds have been wiped.
The old forums will be available for a couple of weeks should you wish to grab old images or classifieds listings content. Go Here
If you have any issues please post about them in the Forum Feedback thread: Go Here
Acetech AT-1000 issue
- Thread starter sharpe
- Start date
Adolf Hamster
Supporters
- Feb 1, 2018
- 7,057
- 2,229
just slightly loose tolerances on the thread pattern of either the gun, the suppressor or both.
as much as i dislike using ptfe tape as i see it far too often done wrong on guns this seems like a situation where it'd actually do the job.
as much as i dislike using ptfe tape as i see it far too often done wrong on guns this seems like a situation where it'd actually do the job.
Adolf Hamster
Supporters
- Feb 1, 2018
- 7,057
- 2,229
Well using ptfe tape (small amounts carefully) seemed to have worked well, worked fine during an evening game. So cheers for that idea
no problem, just bear in mind if you start using ptfe tape on good tight threads, or on stripped threads, i will find you, and i will give you a look of distain.....
Similar threads
