QD suppressor

[Chek]

Found this knackered QD suppressor in my box of junk.  Was going to try to repair it, but looking at it a bit closer, I'm not quite sure how....

Any tips or recommendations? Or is it a write-off and should I just but a new one?

View attachment 123443View attachment 123442View attachment 123441

 

[gavinkempsell]

The black bit's obviously been ripped out at some point bending the thin 'spring' suppose you could try and pop it back in.

View attachment 123444

 

[Sewdhull]

Some thin pliers might help reprofile the spring bit

 

[Chek]

Yeah I've managed to get the small black piece back in, and the spring bit has been manipulate slightly but it just doesn't seem to tighten properly

Also, I shouldn't the small piece have some bars or pins which slide alongside the flash hider?

Maybe I just have to bite the bullet and buy a new one. New parts would probably be just as costly if I could find them. 

 

[gavinkempsell]

the spring has been stretched & may never work properly again without crimping it, I have one that feels brand new & no damage and it feels loose too.