Mk2 CRB shooting a little wild

[ImTriggerHappy]

Theres lots of reasons for a small fps drop on a new gun wouldn't worry unless it keeps degrading.

As for the clunk you mentioned earlier its quite normal. As someone else mentioned its screeches you need to worry about, trust me the little krytac thud is nothing compared to the odd noise my gun makes.

 

[Reality bites]

I've tried to video the 'strays' I'm getting.  I'm aiming for the brown spot on the fence in each and you can see it's not as good a stream of shot as you'd expect.  It was certainly better than this first few games and those strays obviously veer off more at longer distances,. That fence is 11meters away.  At 30yards, those strays are a good couple of feet off target.

Mmmm.....video not the clearest :-(

 

[PT247]

Can see that the camera is moving, so can only assume the gun is too. I'd look at boosting the fps a tad to get closer to your site's limits, that way you would be able to use heavier BBs without them travelling so slow folk can dodge them. I run 0.3g in my 1.14j Krytac. Do remember these are airsoft guns though and will never shoot as well as an air rifle. Is the accuracy the same when shooting on semi? I so rarely fire mine in full auto I've no idea what it's groupings are like on it.

 

[Reality bites]

It's not as bad on semi, however you do notice a flier in every 5-6 shots.  Ive been using 0.25s and have done since owning it.....was fine and should be impacted by the weather so much in the garden at that distance?

You can see the last but one shot veer 3-4 inches left.....I know what you mean about comparing it to air rifles, but it was so bob on in my first few games that I'm noticing it.  Getting feed issues to which is annoying me but may be a mag issue (although it's the mags which cam with the gun)

 

[ImTriggerHappy]

Still think the feed lip on your bucking might be distorted. It can be a difficult thing to spot but will lead to feed issues and inconsistent accuracy.

Problem is without physically having the gun to look at its very hard to diagnose whats wrong with minor inconsistency issues as so many things can affect an AEG.

Just remembered how much I hate the AEG whine when I watched your vid though.

 

[Reality bites]

I will strip it down again and have another look.  I'm going to look at getting a stronger spring installed too.  Now it's settled around the 305-310 mark, I think the next spring will give me a worthwhile boost.