Lowering FPS on m Ruger Superhawk

[fergysonly]

Hello all, recently bought a umarex ruger superhawk 6" (black) because i wanted something a bit fancy although it is arguably impracticable as hell.

Anyway i need to downgrade the fps as its hitting 450-500 fps and i play on an indoor sight (max 350fps)

looked around and i cant find out how to lower the fps. A mate at work suggested it was the hammer hitting the pad thing (cant recall what its called) and the harder it hits the higher the fps and there is a small piece i need to replace to decrease my power. Can anyone point me to the parts i need as i currently have no clue.

Thank, Jake.

 

[jcheeseright]

CO2 revolver? some can get power-down shells, not sure if the ruger has any available... outside of that you're pretty screwed.

 

[fergysonly]

what do you mean power down shell?

also do you no of any leg holsters that could securely hold the ruger? (pretty heavy and i dont trust velcro haha)

 

[jcheeseright]

http://www.airsoftworld.net/dan-wesson-series-power-down-cartridge-12-pack.html

those are for a different type of revolver and reduce the FPS to a manageable level, try looking to see if you can get a similar thing for yours.

 

[fergysonly]

ahh the superhawk doesn't use shells its fed in the cartridge without the shell. (Shown in picture)

 

[Samurai]

Usually cutting the hammer spring does the job on nbb handguns. I don't know about this exact model but if it has a normal spring as a hammer spring, then cut a very little piece of it and check the fps. Half a turn maybe.

 

[fergysonly]

great, tools are at work so will do it next week and will get back to you, thanks

 

[Ian_Gere]

Find out if you can get a replacement spring before you go cutting it, mate, because a balls up will be terminal if not.

 

[Samurai]

If you do cut it too short, you can put a spacer under it to compensate somewhat.