Krytac PDW

If it has less range/accuracy than a standard CM16 then it is broken.

 
Using the standard hop unit and barrel, but upping the fps with a stronger spring and the 30k motor/11.1v LiPo, I was able to get my PDW shooting as accurately and as far as my fully upgraded VSR..... until the OE hop bucking ate itself from the extra forces on it.

 
PT247 said:
If it has less range/accuracy than a standard CM16 then it is broken.
Click to expand...
Click to shrink...
Yep

But on that note I give up because its not like I have ever tested a range of barrel lengths, bores and makes in windless environment with a gun locked in a vice and then done the same with pretty much every hop rubber around. If I had I might know what I was talking about.

 
Blimey...mines nowhere near an upgraded vsr! cm16 has only had a fresh spring and s-hop..so nothing really...I might swap the barrel out of the cm and try it in the pdw... do you know if the laylax nub will fit in the krytac hop up arm?

 
I'm not doubting your knowledge and experience...I'm new to this and just trying to gain some experience and knowledge of my own  :)

 
lazybike said:
Blimey...mines nowhere near an upgraded vsr! cm16 has only had a fresh spring and s-hop..so nothing really...I might swap the barrel out of the cm and try it in the pdw... do you know if the laylax nub will fit in the krytac hop up arm?
Click to expand...
Click to shrink...
Krytac hop arm is proprietary. 

I honestly think your gun is broken if your CM is better. On a 320-400fps gun the Krytac hop is better than anything else I have tried. At 500fps it will eat the bucking but we don't use 500fps guns so it isn't an issue.

Buy a new Krytac bucking and nub, clean the OE Krytac PDW barrel and put it together with a little ptfe tape and the gun should put out 350fps on 0.2g BBs with the hop set to lift 0.3g BBs. If it doesn't put out 350fps on that set up then maybe change the spring. Seriously on a Trident PDW you do not need to do anything, even the ptfe tape is not needed unless you have removed the bucking as it has a fantastic air seal out the box between the bucking/barrel.

 
I don't think its broken..as with the oe barrel it chronos at 340 without ptfe, I will try a new hop rubber and nub though as it won't lift .3's

 
New bucking arrived...and as I had a 200mm barrel from my G5 sitting about I thought I'd try the new bucking on it, really impressed! 8 of 10 shots on a 2ft circle at 40m and 367fps, shame I can't use it! 

Using the standard 155mm barrel and the new bucking I got 342fps with the same accuracy  :)

In conclusion...and ITH will like this...all my pdw needed was a new hop rubber!  :)  

Re-assembled with some ptfe tape 347fps...

 
Last edited by a moderator:
You must log in or register to reply here.
Back
Top