Issue with G26 (marui) not cycling and firing properly

M

Marco

Members
Joined
Nov 20, 2010
Messages
362
Reaction score
5
The gun is cycling but not all BBs are coming out.Also If you look at the video the magazine is empty and its not locking In empty position.I have changed the recoil spring guide and springsI have changed the nozzle but the problem still persistsThe trigger bar and spring seem ok, so the chassis/hammer and slide release bar and spring. I will try changing the loading nozzle spring before checking again the hammer part (I do have a whole hammer and chassis kit from JKW, if compatible I could try to swap it)Any suggestions? Thanks[video]

[/video]

 
Last edited by a moderator:
Have you put a stronger recoil spring in it?

Tried it with the old one back in?

 
Have you tried multiple mags?

Same issue with each one? I can’t see the video, but often poor cycling is due to worn components or mid-matched springs 

 
Thanks.

Yes same issue with all the mags. I have now changed the  nozzle spring too and the issue still persists. i have also added a new recoil guide and springs (guarder)

I'll move next to the  trigger bar and spring, then the hammer set. 

 
In my experience, matching the hammer spring and recoil spring will solve most cycling issues, it doh ds like you don’t have the right hammer spring then

 
Hammer spring is still the original one. I'll try swapping it with the guarder one.  

 
I only changed the recoil spring  because of the issue. Apart from the nozzle the gun was stock. 

Yes the springs are all a guarder set.

 
I can see the video now.

I don’t think your hammer is hitting the release valve in the mag properly.

When/how did the issue start? Is the knocker lock operating correctly can you see?

 
It seems so, btw i have changed the knocker lock spring too, the previous one one a bit bent.

I'll do more experiments this week end, thanks   

 
rocketdogbert said:
I can see the video now.

I don’t think your hammer is hitting the release valve in the mag properly.

When/how did the issue start? Is the knocker lock operating correctly can you see?
Click to expand...
Click to shrink...


So I changed the hammer spring but it  didn't fix the issue, I swapped the whole hammer  assembly with a kjw one but the problem persisted. 

I'll start check the slide assembly now.

Anyone can suggest a technician that service GBB guns?  

 
You must log in or register to reply here.
Back
Top