ICS L85 motor connectors

K

kierant157

Members
Joined
Jan 21, 2018
Messages
5
Reaction score
0
Recently had the wiring on my ICS l85 repaired and all was good, went to install in my L85 and as i was putting the spade connectors on the motor one of them snapped . wanted to know how to get alhold of these spade connectors as they bend on a 90 degree turn. i cant find the original ones anywhere or will standard spade connectors work and fit just fine ?

 
Last edited by a moderator:
As Sako said, Maplins would be the easiest.

Any will do as long as they fit in the space available.

 
They are simply 2.8mm female blade terminals.

Yoi can get them on the Bay if you only need a couple, you can get 90degree ones, I prefer to to crimp my connections, then bend the terminal to 90degree or whatever, then solder, this gives the best conductivity and reinforces the bend ;)

If you've got space you can also use adhesive lined heatshrink for more robust ness 

 
Last edited by a moderator:
This is why I use 4mm RC bullet connectors on short lengths of silicone insulated wire soldered to the motor terminals. ;) But if you've only got space for the spade connectors, then as above run a fillet of solder on the inside of the bend.

 
Davegolf said:
They are simply 2.8mm female blade terminals.

Yoi can get them on the Bay if you only need a couple, you can get 90degree ones, I prefer to to crimp my connections, then bend the terminal to 90degree or whatever, then solder, this gives the best conductivity and reinforces the bend ;)

If you've got space you can also use adhesive lined heatshrink for more robust ness 
Click to expand...
Click to shrink...
Im going to maplins tonight to have a look are all motor spade connectors 2.8 mm or should i go home first and check them 

thanks

 
They are pretty much all 2.8.

In the past i have also soldered direct to the terminal then run them both straight into a Deans.

Depends on the build / use / space.

Assuming this is a straight up repair.

With everything in life, best performance and reliablity is usually the simplest installation, in electrics the minimum number of connections means minimum resistance or points of failure

 
Davegolf said:
They are pretty much all 2.8.

In the past i have also soldered direct to the terminal then run them both straight into a Deans.

Depends on the build / use / space.

Assuming this is a straight up repair.

With everything in life, best performance and reliablity is usually the simplest installation, in electrics the minimum number of connections means minimum resistance or points of failure
Click to expand...
Click to shrink...
yes this is just for a repair and te only size i can find that is 90 degree turn is these ones - http://www.ebay.co.uk/itm/1-4-6-35mm-22-18AWG-90-Degree-Right-Flag-Lucar-Spade-Female-Terminals-x10-red/182417200256?hash=item2a78e99480:g:MvwAAOSwEzxYdQcs

 
You must log in or register to reply here.

Similar threads

Puttees445
Re-named: Star L85 rebuild advice wanted
Replies
9
Views
480
Puttees445
Puttees445
Back
Top