G&G Predator GC16 Disassembly

[terminator9272]

Hello,

Would any be able to tell me how to fully disassemble a G&G predator, I've looked for tutorials and cant find anything. So far, I can get the front handguard off and I push out the large pin located just in front of the mag well but the upper receiver doesn't seem to budge. 

Thanks.

 

[Sako]

Hello,

Would any be able to tell me how to fully disassemble a G&G predator, I've looked for tutorials and cant find anything. So far, I can get the front handguard off and I push out the large pin located just in front of the mag well but the upper receiver doesn't seem to budge. 

Thanks.

Have you tried YouTube as its just the disassembly of an M4 platform Airsoft gun.

 

[terminator9272]

Have you tried YouTube as its just the disassembly of an M4 platform Airsoft gun.

Yes, the front pin is out but the upper section of the gun isnt sliding off

 

[L3wisD]

Try pulling the charging handle slightly as you try to pull the upper receiver forward. Mine sometimes won't come undone without a little wiggling of the handle.

 

[Aengus]

Yes, the front pin is out but the upper section of the gun isnt sliding off

I do this all the time make sure the bolt cover isn't down because it will get caught on the pin.

 

[dazzer306]

When you say fully disassemble, I take it you mean removing stock, hand guard, pistol grip, as well as taking receivers apart, four simples steps, as above, remove front pin, to separate receiver halfs, hand guard is removed by un screwing the four Allen screws/bolts, to remove stock tube, first remove stock look down tube locate screw to undo, next up is grip locate the two small screws o bottom undo, remove wires then motor, look down grip to see two screws undo the carefully pull wires through holes, job do, reassembly is reverse 

 

[Manchego Jones]

I’m having the same problem. Is it only the 2 small Allen screws just forward of the mag well, or are there screws somewhere else that I’m missing?