Flat hop advice

P

ProPain87

Members
Joined
Jun 1, 2017
Messages
159
Reaction score
42
So I'm planning on doing a flat hop, never done one before but looks quite simple. 

All the videos and advice say to use a firefly nub but everywhere seems to be out of stock. Does anyone know either where I can get one or a good alternative. I'd rather buy one  than make one from an eraser or anything unless the results are massively better. I also don't want to r hop,  they seem like so much hassle

Cheers 

 
I have seen them but a lot of people have said they are not very good when searching other threads and forums 

 
I'm happy to use the prommy one if I have to, which would be better black or blue, flat or curved? Other option is maple leaf nub and bucking 

 
Go for the soft, which I think is the blue one. Some people say flat, some say curved, but I've not tried them personally so I couldn't comment.

As far as nubs go the Nazuma works, but I'm tight and I resent paying that much for a small chunk of rubber /urethane when a piece cut out of a pink pencil eraser and glued to the underside of a hop arm that took 3 minutes to sand flat works just as well.

I have tried putting a curve on the underside of nubs, but a can't say there was any noticeable difference, except in the time it took and the number of little bits of rubber I threw away because I'd just buggered it up... again.

If you want to be fancy about it, buy a small sheet of 70 durometer urethane off eBay and make them out of that. It's a lot more durable than the pencil eraser.

 
I found eagle 6 had stock and they were pretty good on shipping, I've just put the prommy blue bucking on and I'm using the prommy black nub with it 

 
Come to think of it, I'm sure I've got a piece of urethane in a box somewhere (one of the ones that hasn't been unpacked since the last time I moved). If I find it, send me a self addressed envelope and you can have enough to do some experiments on the condition you do a thread about your results. ;)

 
Sounds a fair deal, thank you! I'm going to try a few different nubs to see how I get on anyway.  Pm me your address and we can sort it out 

 
The Prometheus black straight bucking is fine. The blue is naff. Most people complain about the blue as it was - until recently - the most readily available.

 
It's the other way around with the Modify. The hard is a bit poor (but OK as a R hop packing) and the soft is the shnizz.

 
I believe the black Pometheus one is actually the softer one too. The blue is in the middle. Could be wrong though.

 
Yeah the blue flat rubber is awful. 

I quickly went back to my (non-flat) purple Prometheus.

 
Modify flathop is a good bit of kit, even if you can just source a nub and then cut down a normal bucking (which I've done on my other gun).

 
You must log in or register to reply here.

Similar threads

A
Advice
2
Replies
21
Views
601
EvilMonkee
EvilMonkee
Back
Top