Many thanks to @ImTriggerHappy the minute my shiny new ASG Scorpion Evo A1 came through the door the 3D printed selector deletes were waiting for it.
Not having taken an Evo apart before I found it quite a challenge. There is a good video online by Patrol Base that disassembles one, but it missed out one vital screw - The one inside the trigger guard.
To remove the lower receiver you need to:
Not having taken an Evo apart before I found it quite a challenge. There is a good video online by Patrol Base that disassembles one, but it missed out one vital screw - The one inside the trigger guard.
To remove the lower receiver you need to:
- Press out the pin (where the stock clips in when folded)
- Remove the motor from the hand grip by removing the two outer hex screws (don't touch the big centre hex as that's motor height adjuster)
- Remove the hand grip. by removing the two hex screws on either side and the four small hex screws from deep inside the grip. Make sure they don't fall into the gearbox!
- Remove the hex screw inside the trigger guard. You'll want a longish allen key to go through the hole in the hand guard
- Then pull the lower receiver down and off.
- You can then position the fire selector(s) so you can get at the tiny hex grub screw that hold them onto the inner gear.
- Once you have loosened the grub screw the inner gear will pull off and you can then replace the outer selector with the replacement indicator.
- Take the tiny grub screw from the existing fire select lever and fit it into the 3D printed replacement indicator
- To get the right one fitted make sure it mirrors the gear positioning and indication mark position of the opposite side
- Reassemble and take regular deep breaths as you swear about trying to get those four tiny screws back into the hand grip.
Last edited by a moderator:
