Eotech setup

[Paulburks]

Anyone using this set up? Eotech I've tried setting it up but it's about 10mm to high from where the bb hits I've tried adjusting the spin wheel on the side but it's at the limit I think. When lining up the centre dot is out, any ideas? 

View attachment 40750

 

[Gepard]

Cut up that protector and place it against the glass inside the sight.

Oh I totally misread that.. Okay quick edit nobody saw nothin'! 

I broke a 552 replica by adjusting it too much so just be careful. 

 

[Guest]

Chinese clone with not enough adjustment.

Shoot at a target further away until it lines up with the red dot

 

[Monkman]

Repo-sights are notorious for having poor adjustment.  Probably just gonna have to compensate the difference when playing with it.  +1 to what Gepard says, cut up the protector using a dremel and glue it inside the holo-sight housing..will look 10x better.

 

[GeorgePlaysAirsoft]

(Bad) luck of the draw im afraid - i have 3 replicas and none of them could be zeroed at all. Could try shimming it otherwise best off trying the budget side of real - primary arms konus etc. The SRS replicas are well regarded too. Appriciate this won't help if you really want the eotech look though. Cheers

 

[Paulburks]

Wow didn't know it was a cheap copy, bloody cost enough lol, well I guess 10mm isn't to bad then just aim higher lol taken note of the glass protector will get that sorted

 

[Guest]

Well, unless you paid over a grand, that and the magnifier are clones ??

 

[Albiscuit]

Just adjust the hop accordingly