Dead gun after shooting 200 bbs with new gears

[Wegalaxy]

Hello,

I have had a new gear set in my ARP 9 which is a 1/14.

These are high speed gears and they are in my ARP 9 with a gate aster installed.

After I had them installed I fired 200 rounds on full auto bursts and semi on 11.1 lipos.

Then nothing, The piston just stopped and a bb was waiting at the end of the nozzle. (I removed the BB).

Now it doesn't beep when I plug in the battery and the aster just flashes red.

It had the stock gears in and worked fine before the install.

What has gone wrong? Any ideas?

Thanks 

 

[mightyjebus]

wires have come off the motor at a guess

 

[Rogerborg]

Yup, always check the simple stuff first: connectors, and wire continuity: a basic multimeter will pay for itself the first time you use it to find a wiring fault.

 

[Wegalaxy]

Thanks.

I will have a look.

Just a quick question.

Using 11.1 lipos with 1/14 gears.

Will this effect the gears life span in the long run?

Are you only supposed to use 7.4s with 1/14?
Thanks 

 

[Lozart]

Thanks.

I will have a look.

Just a quick question.

Using 11.1 lipos with 1/14 gears.

Will this effect the gears life span in the long run?

Are you only supposed to use 7.4s with 1/14?
Thanks 

Bad shimming and/or timing will make more of a difference.

That and an over active Extensor indicis.