Cyma MP5 cm.041j high speed rear sling point

[Ajax]

Hi all 

Santa was kind for me and brought me Cyma Cm.041j MP5A3 high speed. 

Just getting ready for its first game and I noticed that the rear sling point seems to be weak. I was planning to use single point sling and when I hold the weigh of the replica at that sling point it is moving. 

Do you have any experience of this sling point at the sliding stock to fail? Or am I overthinking?

Thanks.

 

[Impulse]

I personally wouldn't run a one point sling since I ran a one point sling with my Cyma mp5k and it snapped off as soon as I started running and it bounced around a bit. Can't say for sure on your one, but the mp5k rear sling loop is awful.

 

[Hatchet]

No experience with the Cyma, but MP5 sliding sling point in general should be fine, there's often a bit of movement, but it can't go anywhere. If you take the stock off you'll see that the sling loop is an L shape with the bottom part of the "L" trapped between the body and the stock mount. You might be able to take up the slack with a bit of electrical tape if it's rattling too much and bothering you. 

The MP5k is a different story, not sure I'd be as confident with that.

You could also make sure your single point sling has some bungee in its design so it's not a hard stop if you drop the weapon.

 

[Ajax]

Thank you for your replies. I'd did tak your advice @Hatchet and add a bit of electrical tape. Hope it will hold

 

[DanBow]

If you take the stock off you'll see that the sling loop is an L shape with the bottom part of the "L" trapped between the body and the stock mount

I know it's an old thread but I had a single point sling on that mount yesterday. I let it drop a little too quickly and the mount came out of the rear receiver, and the rifle nose dived about 2 inches into the wet mud. 

I've had my MP5 apart many times and, I think, the mount needs to be inserted correctly. If the tabs that hold it in had been facing forward, instead of rearwards, I don't think it would have been able to come out, no matter how hard it had been dropped.

I cleared and cleaned the barrel to carry on playing but have just spent a while stripping and thoroughly cleaning the business end of it.

If anyone has a spare sling swivel mount, let me know or if you can point me in the direction of somewhere to get a spare I'd be grateful.