• 2FA temporarily disabled, emails not working

    Two factor authentication (for most of you 'email a code') has been temporarily disabled while we figure out why emails are not being received by large numbers of users. Emails are not sending site-wide. Please continue to use AF-UK as normal but note that you may be asked to log back in once this is re-enabled.

CTM holster with Amomax belt clip

ParHunter

Members
Joined
May 12, 2023
Messages
148
Reaction score
128
View attachment 118116View attachment 118117View attachment 118118Hi,

I bought a CTM holster for my AAP-01 and an Amomax belt clip. The CTM has a belt clip that is attached with 3 screws but I prefer the Amomax belt clip.

However I am confused on how to properly set it up. The Amomax only has one hole in the centre. If I use one of the back plates of the CTM with one hole or even the back plate with the 3 holes and tighten the one center screw so that the holster stays in place, then the spring powered release clip doesn’t move anymore. 

When you look at the back you can see that if you tighten the back plate the swivel for the release clip is locked in place (see picture showing the back). 

So how is this supposed to be attached? Did I use the wrong backing plate?

 
Back
Top