AEG Hop Rubber Fitment

[Cr0-Magnon]

I'm not actually using a Maxx hop unit but this is the only pic I could find with a notch where the barrel clip goes. Anyway, when fitting a hop rubber I can still see it through this notch, does it need to be trimmed a little bit until I can't see it at all?

View attachment 104216

 

[alxndrhll]

I'm not actually using a Maxx hop unit but this is the only pic I could find with a notch where the barrel clip goes. Anyway, when fitting a hop rubber I can still see it through this notch, does it need to be trimmed a little bit until I can't see it at all?

View attachment 104216

Certainly not an expert but whenever this has been the case for me I’ve trimmed it if the C clip won’t engage properly, leaving the hop unit not secured into place with the barrel. If the C clip still fully clips in there isn’t really any reason to though.

 

[Davegolf]

Yeh just shorten the rubber down

 

[Cr0-Magnon]

OK, cool. Cheers guys.

 

[Adolf Hamster]

If the clip fits don't worry about it.

You might want to check the rubber isn't getting stretched when pushing the barrel into the hop unit.

Made the mistake of buying a madbull hop unit which was so damn tight it would pull the hop unit over the end of the barrel when fitting.

 

[Cr0-Magnon]

I shortened it a smidge, so it sits literally flush to the back of the clip. Think that'll do. 

Now all I need to figure out is how to keep the motor connectors on this ERG ?....the positive keeps popping off.

 

[Davegolf]

Can’t you just pinch the connector a little tighter?