Tokyo Marui M4A1 - snapped plastic hinge - options?

[APV]

We have a 3d printer but I don't think that will help in this case - does anyone have any ideas?

View attachment 142481

 

[Tackle]

Forget trying to repair it, you could put an ad in the "parts wanted" section, bound to be members who have upgraded to metal bodies have these sitting in the spares box ?

 

[Anonymoose]

The Marui MWSs are plastic-bodied? ?

 

[Hudson]

This is the old style M4A1 AEG.

 

[mightyjebus]

the tabs snapping was quite a common problem with these old TM rifles. If you still have the broken tabs then you could cut metal tabs from a coke can and epoxy it on again using the coke can tabs as reinforcement.

The easier option would be a replacement metal upper and lower receiver however you will need a hop unit as well as the old TM M4's had a 2 piece hop unit that only fit the TM plastic receivers. Back in the early days of Airsoft Guarder, Hurricane and Systema made some very good replacement receivers.

 

[Colin Allen]

One thing I did on a similar gun years ago was to drill small holes in the back of the upper receiver and glue metal pins into them so that they stuck out backwards, sliding under the upper part of the lower receiver when assembled.

 

[Chev Chelios]

Large zip tie works fine until a replacement can be found.  

 

[pyromancer6]

Large zip tie works fine until a replacement can be found.  

£550 upgraded. I know what I got. No time Wasters

 

[Lozart]

We have a 3d printer but I don't think that will help in this case - does anyone have any ideas?

View attachment 142481

I'm having a clearout over the next week or so, pretty sure I have an old TM plastic receiver. I'll let you know!