-
Hi Guest. Welcome to the new forums. All of your posts and personal messages have been migrated. Attachments (i.e. images) and The (Old) Classifieds have been wiped.
The old forums will be available for a couple of weeks should you wish to grab old images or classifieds listings content. Go Here
If you have any issues please post about them in the Forum Feedback thread: Go Here
JG Works M14A EBR - Upgrades
- Thread starter Jmason98
- Start date
Lozart
Supporters
- Jun 24, 2013
- 8,495
- 4,943
The JG is a TM clone (same as the Cyma) so as far as internals go, standard hop rubber should fit fine but be aware that ones with a longer feed lip (like the Maple Leaf ones) may protrude into the feed tube a bit.
As for barrels, just make sure it has both sets of grooves in the side of the barrel, the hop unit clip goes in a different place than on an M4. ZCI ones will work, or if you want to spunk a bunch more cash, Prometheus do an M14 specific one. You're looking for something around 420mm length. Worth mentioning though that if the cylinder is the same sort of size as a TM or Cyma, changing to a tighter bore will push your FPS up a not inconsiderable amount!
As for barrels, just make sure it has both sets of grooves in the side of the barrel, the hop unit clip goes in a different place than on an M4. ZCI ones will work, or if you want to spunk a bunch more cash, Prometheus do an M14 specific one. You're looking for something around 420mm length. Worth mentioning though that if the cylinder is the same sort of size as a TM or Cyma, changing to a tighter bore will push your FPS up a not inconsiderable amount!
Similar threads
