How to tighten how to a G&G GR16 outer barrel???

[ronin677]

Hi all,

My G&G GR16 outer barrel has started to get a very slight wobble to it. I've never had to strip my weapon down to remove the outer barrel before, although I am adept at taking it apart in most other senses.

Does anyone know how to tighten the outer barrel? Advice will prevent me learning from trial and error and getting it wrong before I figure it out.

Any help would be appreciated.

My G&G GR16



thanks

Jon

 

[Monty]

take the handguard off and look near the delta ring, there might be two screws, one on top and one on the bottom. it's like that on the combat machines anyway.

 

[ronin677]

Thanks Monty,

Thats exactly how to tighten it All tightened

cheers

 

[n1ckh]

The same keeps happening on sons M4, I take off the delta ring, tighten the ring underneath and then it keeps happening there's no grub screws, I've wrapped insulation tape tightly around the thread on the body and it still happens, I've got to try something else but not sure what to do

 

[jcheeseright]

loctite.

 

[ronin677]

Here's the grub screws that I had to tighten if that helps. There is one either side of the barrel

 

[Mr Monkey Nuts]

I would be tempted to insulate those exposed wires a little better, you don't want them shorting.

 

[ronin677]

I would be tempted to insulate those exposed wires a little better, you don't want them shorting.

Click to shrink...

Funny you should say that haha. I've just ordered new wiring and connectors to give this a service over christmas