• Hi Guest. Welcome to the new forums. All of your posts and personal messages have been migrated. Attachments (i.e. images) and The (Old) Classifieds have been wiped.

    The old forums will be available for a couple of weeks should you wish to grab old images or classifieds listings content. Go Here

    If you have any issues please post about them in the Forum Feedback thread: Go Here

Double Eagle AK-47 Krinkov CQB AEG

Status
Not open for further replies.

Governor

Members
Joined
Oct 9, 2010
Messages
308
Reaction score
10
The other day i was shooting my gun at cans to do the (rough) FPS test and it started to smoke.

I later looked at the gun and where you put in the battery the wire connected to the gun was a bit shriveled up and loked like it had been slightly melted, no wire was showing.

Is there anyway i can prevent this from happening again?

Thanks, Albert

 
has the fuse blown

just sounds like the wires got hot and melted, due to the poor make,

the fuse should blow to stop this, but i would recomend strip it down, and replaced the electrics with a TM set, the electrics are so much better

 
Last edited by a moderator:
has the fuse blown
just sounds like the wires got hot and melted, due to the poor make,

the fuse should blow to stop this, but i would recomend strip it down, and replaced the electrics with a TM set, the electrics are so much better
where can i get the tm wires from and would it be easy(ish)

thanks, Albert

 
TBH if you start buying TM parts its going to end up costing you more then its worth

 
Status
Not open for further replies.
Back
Top