Conversion Kits.

T

taroslice

Members
Joined
Dec 17, 2010
Messages
68
Reaction score
0
I've had a terrible wobble on my G&P m4 and been told happens to alot of their m4's?

Tried getting it prepared but the only option the guy gave me was to super glue it together...and i wasn't too keen on it.

So i've thought about conversion kits...

But from my view is it just removing all the internals of my m4 and move it into another gun?

Cause to me...all airsoft guns are basically the same internally, its more going for the LOOK of the gun.

 
Look for an accuwedge, that might help

Or, put a rubber o-ring around the bit on the upper receiver that

Is it a gbbr?the pin goes through (if you know what I mean?) If not say and ill get a picture

 
G&P's are known for the gap between receiver halves, though I've never known them to wobble

 
I had a Dboys M4 some time ago with a similar problem. The solution was a gasket made from thin black card, which was fixed with double sided tape to the lower receiver. Worked like a charm :)

The receiver on my G&P Magpul doesn't appear to have this problem at all. It's nice and tight.

 
You must log in or register to reply here.
Back
Top