Lancer Tactical Nightwing Boneyard

[strykerles]

Just purchased the above gun and it apparently has the following issues

 

Whiney motor

loose stock

 

I'm assuming it will either need to motor height adjusting or the AOE changing, I already have another buffer tube as the advert says it's bent

If I am going to crack it open would there be any other things I should consider changing while it's open?

 

thanks for looking

[Sitting Duck]

What MIGHT be inside....

 

 

 

now could ANYTHING from a shitty micro-switch POS to a basic trigger/trolley

but as said MIGHT be like BattleHawk internals...

 

At first glance it looks like an Ultimate/Lonex gearbox but Lonex tappet plates have cut out like Cyma V2's

(where extra material is upfront & INSIDE the Cyma box, hence the tappet is cut/stepped at front)

 

I don't see a stepped tappet plate so not quite a Lonex oem box like it looks like

or nope the tappet isn't stepped...

 

 

Think Ultimate have a "regular" tappet plate - not stepped

but I see people refer to them as Ultimate/Lonex as nigh on same box

so who knows if they share stuff or have revised things

 

From the looks of things, it seems that Lonex make the stepped tappet plate

but the pic seems to show no real pronounced extra material inside like Cyma V2's

 

So maybe Lonex are Ultimate's and you might have an oem type box with fancy mosfet if you're lucky

Though classic Lonex/Ultimate's were not QC springs, likely something like the TomTac V2 boxes

(they were QC springs but looked like Lonex - but weren't)

But who knows what is there, likely a oem TomTac type box LT seem to use in higher end guns with fancy ETU

 

Could be an oem SA box, not really up on recent boxes tbh

gears look std China gears - probably OK, box isn't reinforced so 13:1's drop straight in

motor entry point has little support for for motor tower/sleeve

(common on non reinforced boxes), so ensure motor doesn't slop about in pistol grip

(or motor really will jump all over the place and whine)

 

Looks OK, think it was the look of the gun than the brand that caught your eye

could just give  it a service & the once over, but scope to go a little crazy perhaps

though unsure how the ETU will hold up and being bespoke I'd keep it as is tbh

than build it with more snap & stress

 

anyway - hope the clip gives you a clue what MIGHT be inside

[strykerles]

thanks for that, must say I do like the externals :D

 

and half retail price with possibly only a couple of small faults it's worth a punt