Jump to content

250 Round Midcaps - EPM1 by PTS and ODIN Innovations


BibbsOnTour
This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and possibly forgotten) topic.

Recommended Posts

  • Supporters

I bought a cheap clone, partly because I didn't realise that it was a rip off of an original design, and partly because a genuine one is too rich for my wallet and occasional use at a CQB site with a very low ROF.

 

The sticky-out part of the handle will come off on the clones.  They all do.  But the winder mechanism itself is still usable, just cable-tie or key-ring a new handle on.

 

And you can use them to fill mags other than M4 if you can find an M4-magwell-to-your-mag adaptor - I use mine to fill MP5 mags.

Link to comment
Share on other sites

1 hour ago, Rogerborg said:

The sticky-out part of the handle will come off on the clones.  They all do.  But the winder mechanism itself is still usable, just cable-tie or key-ring a new handle on.

 

And you can use them to fill mags other than M4 if you can find an M4-magwell-to-your-mag adaptor - I use mine to fill MP5 mags.

 

Yeah I mean ultimately if your clone breaks you could just buy the rebuild/spares kit for 10 quid and you'll end up with 80-90% of the mechanism components as genuine and that way your paying something back to the OG manufacturer while not breaking the bank...  den evy bodeh happeh! 😃

https://www.fire-support.co.uk/product/odin-m12-loader-rebuild-kit-crankpaddle-wheelmag-release-etc

https://www.ebay.co.uk/itm/142966769746

 

I've been meaning to get some of the adapters, need MP5/AK/G36. I've read a couple reviews where people say they only can get a half filled mag using the adapters, but i'm fairly certain those guys are just unaware that they need to tighten up the clutch a bit.

 

This shop actually does a lot of custom 3d parts for the Odin including pretty much every adapter model you can think of:

https://isashop.eu/816-3d-prints#/prijs-0-110

 

Of particular interest to me is this piece: 

https://isashop.eu/speedloader-adapters/12736-m12-sidewinder-paddle-wheel-replacement.html

I'm not sure, but I've got a feeling the 4 pushers (as opposed to 6 on the og) may allow 4 BBs per segment, which would mean 16 rounds per rotation...  dat lil bit extra like! 😎

 

Link to comment
Share on other sites

  • 1 month later...
13 hours ago, Jimbodini42 said:


 

Anyone seen if the mid caps are available UK anywhere yet?? Unfruitful searches for me 

I've not heard anything so far... eager to get my hands on em for my next build haha

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...