Jump to content

WE M92 Full Metal issues


Blueforce
This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and possibly forgotten) topic.

Recommended Posts

Hey there, I just bought this gun and I'm having a few issues and I'd like to know your ideas on it.... slide works even on safe. 

safety gets locked between safe and fire (full auto position) and works (semi). slide gets stuck (probably on hammer) but also the nozzle stays fixed on the barrel until I pull further/harder. Is this common for WE?

Link to comment
Share on other sites

Its working fine.

The 'safety' lever is a decocker so do not try force it on.

 

- Leave it up in the fire mode.

- Rack the slide (to load a round)

- Push the lever down to decock it. Its now in safe

- Lift it up when you are ready to fire.

 

The idea behind this is to be ready to fire without having to rack.

Of course its double action so not completely necessary.

 

When a magazine is loaded with gas DO NOT try to decock by holding the hammer as you pull the trigger!!!

This could fire a round as the internal hammer still hits the gas valve.

 

You can safely decock by holding the hammer and pull the trigger if you first remove the mag.

Link to comment
Share on other sites

Must be a different model to mine tho still WE.

Mine does not hold the slide when safe either.

 

I was told not to rack the slide when the lever is down in safe.

Link to comment
Share on other sites

there is nothing wrong with it my Tm one and my KJ works m9 are the same also my grandsons src m92 all do the same the nozzle will stop sticking after you have used it also use silicone oil as i have found that they tend to like lots of lubrication.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...