Kappeag Posted June 23, 2019 Share Posted June 23, 2019 Hi! After recently disassembling my m4 i cant get my front receiver pin to go all the way through. I tried to hammer it in with a rubber hammer but that didn't work either. Is there anyone who got some tip or trick to get it to work? Link to comment Share on other sites More sharing options...
Supporters Prisce Posted June 24, 2019 Supporters Share Posted June 24, 2019 Are you sure it’s in the right way round? It only goes in from one side. May seem a little harsh. But I wouldn’t be suggesting it if I hadn’t made the same mistake myself. Link to comment Share on other sites More sharing options...
Kappeag Posted June 24, 2019 Author Share Posted June 24, 2019 yepp, it's the right way around Link to comment Share on other sites More sharing options...
Supporters Lozart Posted June 24, 2019 Supporters Share Posted June 24, 2019 Have you checked that you can actually see the upper and lower lining up properly? The main receiver pins shouldn't be hard to get in at all! Link to comment Share on other sites More sharing options...
Kappeag Posted June 24, 2019 Author Share Posted June 24, 2019 it doesn't line up perfectly, thinking about drilling the last way. Link to comment Share on other sites More sharing options...
Kappeag Posted June 24, 2019 Author Share Posted June 24, 2019 managed to widen the exit hole, it slides in relatively smoothly now Link to comment Share on other sites More sharing options...
Supporters Tackle Posted June 24, 2019 Supporters Share Posted June 24, 2019 give it a couple of games, it'll be like kicking a sausage up oxford st 😉 Link to comment Share on other sites More sharing options...
Kappeag Posted June 24, 2019 Author Share Posted June 24, 2019 i will pretend i understood that joke Link to comment Share on other sites More sharing options...
Supporters Tackle Posted June 25, 2019 Supporters Share Posted June 25, 2019 2 hours ago, Kappeag said: i will pretend i understood that joke I was referring to the fact that you have drilled the hole bigger, which over time may allow flex in use, which in turn could cause the hole size to increase....not a good outcome. my reference, an old slang term, can be explained here: https://www.urbandictionary.com/define.php?term=throwing a sausage up a close enjoy😜 Link to comment Share on other sites More sharing options...
Supporters Lozart Posted June 25, 2019 Supporters Share Posted June 25, 2019 17 hours ago, Kappeag said: it doesn't line up perfectly, thinking about drilling the last way. 17 hours ago, Kappeag said: managed to widen the exit hole, it slides in relatively smoothly now Thing is, they're supposed to be a close fit. If they don't line up without modification it means that something else is out of line elsewhere. You've addressed the symptom but not the cause so you may find you have more issues down the road. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.