Jump to content

SAR-21 custom


ryanlim2000
This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and possibly forgotten) topic.

Recommended Posts

Hey, 

 

Not sure where this goes, but I'm planning to get an ICS L85 or a spring L85 to tear it apart and put a 3D printed SAR-21 exterior on it. I've been advised previously to get an AUG, but due to the cost of AUGs against the L85, I'll probably go with it. 

 

Been looking at 3D printing for the parts and its come up to around USD70-100 for them to design out the parts as per military specifications, but I've not checked for the cost of 3D printing yet. The 3D printing person was going to do it with all the rifle parts as well, but I'm not sure if thats a good idea, or how much of the rifle parts to keep. The main issue I'm facing is that the firing chamber is part of the system that holds the rifle in place and how would I fit an AEG or spring rifle's parts inside this "shell"

 

Cheers

CIMG7490.jpg

SAR-21.jpg

CIMG7491.jpg

CIMG7495.jpg

CIMG7497.jpg

CIMG7501.jpg

CIMG7502.jpg

CIMG7503.jpg

CIMG7504.jpg

CIMG7506.jpg

CIMG7509.jpg

CIMG7511.jpg

CIMG7513.jpg

CIMG7517.jpg

CIMG7518.jpg

CIMG7519.jpg

CIMG7523.jpg

CIMG7525.jpg

CIMG7526.jpg

CIMG7527.jpg

CIMG7529.jpg

CIMG7530.jpg

CIMG7533.jpg

CIMG7534.jpg

CIMG7536.jpg

CIMG7537.jpg

CIMG7540.jpg

CIMG7542.jpg

CIMG7466.jpg

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...