Jump to content

Torch pressure switch mounting


E21A
This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and possibly forgotten) topic.

Recommended Posts

I’ve bought myself a rail mounted torch with pressure switch for an upcoming visit to the mall. Question is where do I mount the switch? 

 

Any suggestions appreciated. I’m currently thinking on the foregrip but I’m all ears 

Link to comment
Share on other sites

Do you use a handgrip? Could mount to this or on handguard rails. 

Link to comment
Share on other sites

8 minutes ago, L3wisD said:

Mine is wiggled through the keymod handguard and held onto my vertical grip with self-amalgamating tape.

 

Does the job very well 

 

fMny0HF.jpg

 

YO1zySi.jpg

 

This is exactly what I’m thinking of doing. Good to know it works well. 

Link to comment
Share on other sites

I stick mine to the foregrip with sticky back velcro.

Link to comment
Share on other sites

Threaded through the rail and grip and held in place with tape of some kind.

Link to comment
Share on other sites

  • Supporters

I prefer mine on the side of the fore-end above a vertical grip but everyone's different. Get something non-permanent like cable ties and try it in a number of places and see where you like it best

Link to comment
Share on other sites

  • Supporters

When I used one I preferred the switch on a vertical grip, though that’s only because I put the switch for my PEQ on the 11 o clock position on the rail.  If you’re not using a laser then that’s where I would go,  sits perfectly for your thumb

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...