Jump to content

Kill flash/Lens protector.


Sam Moya
This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and possibly forgotten) topic.

Recommended Posts

Hey all.

So for a while now I've been looking for a lens protector for my rifles scope,

Now I either have to pay an arm and a leg or play the guessing game on eBay and hope I get the correct part.

No, not happening, so here below is anot easys guide on how to make one yourself. Only cost around 10 pounds including paint.

Fingers crossed I got the image links right..

 

https://imgur.com/Qa1KTTC

 

So first I bought this piece of mesh from BnQ

 

http://i.imgur.com/ZiKrghi.jpg

 

You'll want to draw around your scopes sunshade and add these four points at each side (circle,sides yeah I know)

 

http://i.imgur.com/qAPLyQZ.jpg

 

Place over your sun shade.

 

http://i.imgur.com/6Jlhkvp.jpg

 

Now gently push your lens cap over the top of the mesh... or if you don't have a lens cap you can just use some strong sniper tape electrical tape etc.

 

http://i.imgur.com/8VF25Cx.jpg

 

End product.

 

http://i.imgur.com/V5qonFL.jpg

 

Just to show you can't see the mesh through the scope.

 

So there you go people I hope this helped, I recommend some sharp wire snips for this makes it all very simple.

Link to comment
Share on other sites

I've fired my KSC USP at almost point blank (couple inches away) and it took about 5 shots to really dent the mesh. I think at any real range, say 30 feet away you'd be laughing.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...