Jump to content

PSS10 Zero trigger - Slam firing


Monty
 Share

This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and possibly forgotten) topic.

Recommended Posts

  • Supporters

As per title, trigger is absolutely fine, sear is in tact, I'm also using PSS2 piston. I've checked that the sear engages with the piston, and it does, just when everything's fixed together it decides that it doesn't want to work. Any suggestions? I'm thinking that the bolt isn't going back far enough for the piston to go past the sear to make it engage, but I'm not sure.

 

 

Link to comment
Share on other sites

  • Supporters

How did you check if the sear is engaging?

 

Pushing it, (simulating that it's cocked) then pulling the trigger to see if the sear disengages, which it does.

 

( ͡° ͜ʖ ͡°)
Link to comment
Share on other sites

Guest PT247

return spring snapped?

 

trigger guard too tightly screwed in place?

 

screw to the rear of the magwell too tight?

Link to comment
Share on other sites

  • Root Admin

Yeh, the bottom two PT247 said were what I was going to suggest - that's why I was asking how you tested :D A lot of people overtighten and strip the receiver screw holes or just seat the sear slightly too high for some pistons.

Link to comment
Share on other sites

  • Supporters

return spring snapped?

 

trigger guard too tightly screwed in place?

 

screw to the rear of the magwell too tight?

 

I'll have a look at these when I get time, good suggestions.

Link to comment
Share on other sites

This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and possibly forgotten) topic.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...