Jump to content
Sign in to follow this  
proffrink

Mancraft regulator issues

Recommended Posts

I just saw this on their Facebook page. I know a few of you use the SDiK so I felt it worth sharing:

 

Reducers will next week for the store / regulators will be he shop in next week: D.

 

Revised Valve Pressure Regulator. Valve causes no jumps pressure (which is sometimes so often, especially at low pressures). From 19.11.2015 is mounted standard in reduktorach. With The Kit Recovery Falls Valve and two sealing of different twardościach. If Pressure Regulator Works correctly - don't buy, too bad money wink emoticon.

 

Because one of our test cylinder hp malfunctioned, anyone we order has been shipped between 10.11.2015-19.11.2015-please przestestować pressure regulator and if trouble - please contact ^^.

 

http://shop-mancraft.com/pl/glowna/63-zawor-reduktora.html

 

https://youtu.be/jzUmkAMAgBk

 

Updated regulator valve. Valve does not cause pressure peaks (as sometimes happened, especially at low pressures). From 19.11.2015 as standard in the regulators. The repair kit includes valve and two sealing of different hardness. If the regulator is working properly - do not buy, dont waste your money;).

 

Since one of our regulator testing HP tanks went wrong, everybody who's order has been send (not placed but send) between 10.11.2015-19.11.2015 - please test your regulator, notice the results and if something wrong, contact us ^^.

 

http://shop-mancraft.com/en/glowna/63-regulator-valve.html

 

https://www.youtube.com/edit?o=U&video_id=jzUmkAMAgBk

 

Sorry for crappy quality of the video wink emoticon.

G6SwtC0.jpg

Share this post


Link to post
Share on other sites

Proffink give it about 300 shots or so and i think the regulator settles in, i found mine was a bit weird in that when i set it for 500FPS after about 10 or so shots without moving the regulator i was up to 560FPS, but as i say it has since settled down now.

Share this post


Link to post
Share on other sites

I'm searching for a better 4mm to 6mm push fit for my HPA rig! At the moment I use a 4mm push fit with a male foster that plugs in however it's prone to leaking. Ideally I need a compression style fitting.

Share this post


Link to post
Share on other sites

The best place for quite a few pneumatic fittings that I've found is http://uk.rs-online.com - their website is horrible to navigate but you might be able to find something there. I agree with you that push-fittings are naff. That's why I switched my HPA guns to EU QDs that have compression fittings because I'd rather not dump an entire tank one day when the fitting gives in.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×