Jump to content
Sign in to follow this  
el5hag5hag

G&G G96 bolts 'valve knocker' not sitting properly

This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and probably forgotten) topic.

Recommended Posts

You can see how it sits in this image http://i.imgur.com/806k98k.jpg



As far as I can tell it should push all the way forward into that space where you can just make out the spring.



My sniper is not firing because no gas is being released from the mag. The lever within the trigger does not push out against the magazine when the gun is cocked. This is because the valve knocker in the bolt does not go far enough forward to push against the lever. I have taken it apart to see what I can change but I am unsure.



I have played with the bolt a lot and I cant see how to fix it, this might not be a common problem but if anyone owns this gun I would be grateful for any advice or photos on how the valve knocker mechanism works.



Any help would be much appreciated.


post-10201-0-64010200-1411909406_thumb.jpg

Share this post


Link to post
Share on other sites
This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and probably forgotten) topic.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×
×
  • Create New...