Jump to content
Sign in to follow this  
Trojan

Airsoft Motor Misalignment

Recommended Posts

Hi there,

I have a stock pistol grip and a Lonex A2 motor meshing with my stock KA gears. (KA Colt M4)

The problem is that after a LOT of trouble shooting and diagnostics I have eventually figured out that the gun screeches not because of the shim job but because of the slight off-centered angle of the motor.

Here is a picture of the pistol grip with the height adjustment tool removed: gdaXxCP.jpg

I want to know if any of you can think of ways to correctly adjust this. To confirm, I did wedge a Flathead screw driver into there to correct the positioning and it worked! My shim job came out near perfect and my gears spinned so nicely with very little noise.

I tried Maekis sanding down of the pistol grip and that did help considerably as one of my original problems were that as the pistol grip went over the bevel gears bearings it tightened it as well as ruining the shim job - but maekis fix did not fix my misalignment.


Any help is greatly appreciated as I've been struggling for so long now! :P

Share this post


Link to post
Share on other sites

Bit of gaffa tape on one side of the motor to pack it out?

Share this post


Link to post
Share on other sites

I would but i need the tape on the top right ish of the motor, at an awkward angle or the motor wouldnt fit in the pistol grip as its tight in the arleady... I put tape on the pistol base grip lip (where it catches the endball of the motor) and that fixed it..but it isnt very secure and fell out cause the tape doesnt really have much area to grasp.

Share this post


Link to post
Share on other sites

OK, how about you cut a small piece of tape and stick it to the inside of the pistol grip instead?

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...