Jump to content

Archived

This topic is now archived and is closed to further replies.

-Marksman

Parts from ASPUK Arrived :)

This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and probably forgotten) thread.

Recommended Posts

Parts arrived today & could not be more pleased :) Boosted my fps from around 390 with a .2 to 525 with a .2 :o


The only problem is the old spring guide in my gun has a hole in the middle where a rod goes through to stop it from wobbling I suppose, the new one does not so I cant fit that bit just yet.


Other than that all is good, the trigger box seems to be taking a beating so I will get some new sears soon, also for some reason when I fire the gun it knocks the mag out from the side it does not get locked in :P


P1030104_zpsb0eae92c.jpg


Stock parts taken out:


P1030105_zpsa049621b.jpg


New parts fitted :)


P1030107_zps55503983.jpg


Ugly orange :mad:


P1030092_zpse3746171.jpg


Not to worried about the fps at the moment, my sites limit for snipers is 500 but you have to be 18 to use them there no matter what fps.

Share this post


Link to post
Share on other sites

That long metal pin is actually an indicator to show its been cocked but that doesn't work on clones. Just take it out.

Share this post


Link to post
Share on other sites

That long metal pin is actually an indicator to show its been cocked but that doesn't work on clones. Just take it out.

how would i go about taking it out?

Share this post


Link to post
Share on other sites

Take out the alan key screw that holds the handle to the cylinder. (There is 2 small metal pieces DO NOT LOSE THEM! They will fall out of place but just use needle nose pliers to put the back)

One the handle is off you'll see the tip of the pin, just pull it out & thats it.

Share this post


Link to post
Share on other sites

×
×
  • Create New...