Jump to content

Archived

This topic is now archived and is closed to further replies.

Liam Porter

M4 Receiver with "Burst" rather than "Auto" engraved on it, and ASCU Gen.3?

Recommended Posts

I'm considering an M4 build, but I want it to be different to all the rest. One thing I've never seen is an M4 with burst and with "burst" engraved onto the receiver in place of "auto".

 

I thought I had found one, but when I looked closer at the picture, it was an M16A4 receiver, quite a let down as it was in the M4 category.

 

So, does anyone know if one actually exists? And if so, where are they available?

 

 

 

On a side note, I've recently seen the Airsoft Systems Smart Control Unit (ASCU) Gen.3 available, but for the same price as the Gen.2.

 

Anyone know any differences between the two?

 

 

Thanks

Share this post


Link to post
Share on other sites

Well, To be fair, if it is just the receivers you are after, All AR-15 receivers are the stock design.

 

As for doing the engraving, You can geta rotorary kit on amazon pretty heap (paid £16 for mine) and it comes with the bits for engraving, although id say practice alot before doing something you actually want to look pretty as Its not as easy as i thought it would be to do :S

Share this post


Link to post
Share on other sites

That's not a bad idea, but it would annoy me so much if the trademarks aren't exactly realistic and if the receiver isn't the same quality as the G&P ones. So if you know where I can get a G&P quality receiver that's blank, and in the slightly grey colour rather than actual black, that'd be great.

Share this post


Link to post
Share on other sites

well, If the markings are engraved you just use a filler and sand down.

And if its printed trades, then just rub them off.

Thats usuallay what I do, as for film/production thats what I have to do on pretty much everything because we cant show any branding.

You can usually find pretty good recivers about which are good quality metal so easy to work with.

Share this post


Link to post
Share on other sites

From what I have read the ASCU V3 isn't as good as the V2 version. The trigger response doesn't seem as responsive as V2. The only thing it has for it, is the fact that it is one board so no data cables to snag and no extra space taken up in the stock tube.

Share this post


Link to post
Share on other sites

i had a blank reciever at one point and what i would reccomend is to find a blank one then send it off to airsoft engraver and he will do full trademarks for you at a decent price

Share this post


Link to post
Share on other sites

Yes but he's the same guy who runs ptwairsoft- he's not known for being hugely reliable or quick for that matter.

Share this post


Link to post
Share on other sites

His work is extremely impressive admittedly but I don't think I'd trust sending something expensive his way :D

Share this post


Link to post
Share on other sites

×
×
  • Create New...