Hey Guys,
I'm having a go at a little project after a friend of mine removed his G&G G2 ETU and replaced it with a gate titan. Rather than throw the ETU away I took it off his hands and have successfully (mechanically speaking) installed it into my setup. The issue I am having is connecting the ETU's 4-cable signal wire system to the Gate NanoHard 2-cable signal wires. I can only get my rifle to fire in full auto which is a problem for the sites I play at.
Does anyone know if the G2 Mosfet that comes with the ETU physically controls the power sent to the motor based on the signals sent from the ETU? Or is the ETU a micro-circuit that I could reconfigure to only
Here's what I have done:
- Permanently bridged the "empty mag" function switch on the ETU to recreate always having bbs in the mag. (and because my pal, in his infinite wisdom cut the switch off the PCB!)
- Correctly Installed ETU into my ICS CXP-APE V2 Gearbox.
- Guided 4-wire signal system to my rear wired Gate NanoHard.
- Connected the Ground and "Switch 1" wires to the 2 signal wire posts on the Gate NanoHard
Issue:
- Gun only has safe/full auto functionality. Single-shot still fires full auto.
- I don't know how the original ETU works and if the MOSFET that came with the G2 gearbox (that I don't have access to) was needed to control the ETU or if it uses the other two wires for diagnostics only?
Bit of a complicated one, but I can always just chuck the standard trigger and contacts back in. I'd just prefer the ETUs microswitch as it's much more consistent!
